Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
- Wheels and tyres
   Wheels
   Wide tyres and wheels
   Pressure check in tyres
   The control of a condition of tyres
   Wheel replacement
   The control of an inhaling of wheel bolts
   Balancing of wheels
   Purchase of new tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications



Wheel replacement

If the serviceable wheel balanced on the car – for example after the control of a condition of brakes it needs to be tightened on a wheel nave in the same position, as before removal is established. For this purpose it is necessary to note position on a rim (2) and a nave of a wheel (1).

Wheel replacement in a way – not absolutely simple business. Bolts for wheel fastening can appear приржавевшими or at last replacement of wheels in a workshop them "have slammed" shock гайковертом (instead of as it is necessary to tighten the moment 110 Н•м). In this case the onboard tool will not help you, the powerful key for an inhaling of bolts of fastening of wheels or крестовидный a key with the put on piece of a pipe for lengthening of the lever of force is necessary.

 PERFORMANCE ORDER

  1. To put the car on a lay brake and to include the first either a reverse gear or parking blocking.
  2. On road to include the emergency light alarm system and to establish a sign on an emergency stop.
  3. To block opposite side wheels, for example stones or wooden брусками that they did not move.
  4. Insert fingers into apertures of a wheel cap and remove it.
  5. If on the car stand легкосплавные wheels with secret fastening insert a screw-driver into lateral dredging on a cap and remove a cap.
  6. Open a key "a confidential" bolt for fastening of wheels if that costs on your car.
  7. To weaken bolts for fastening of wheels – everyone approximately on a turn.
  8. To establish an onboard jack on the basis of the car скосом inside on the designated place of a bottom edge of a body (section the workplace Organization). The jack should enter thus in vertical распорку bodies.
  9. On the soft earth it is necessary to enclose a plate under a jack.
  10. To lift the car.
  11. Completely to turn out bolts for wheel fastening.
  12. To remove a wheel, to put on a spare wheel. The aligning pin from an onboard tooling if it before wheel installation to screw in a bolt aperture thus can help.
  13. To put консистентную or liquid greasing on a cone and a carving of a bolt for fastening of wheels.
  14. In regular intervals and перекрестно to tighten bolts. Thus to turn a wheel that in one, in other party that it was faultlessly aligned on a nave.
  15. To lower the car, дозатянуть bolts (110 Н•м).
  16. To put on a cap. To pay attention to cut for a tyre nipple.
  17. After a short trip to check up strong landing of bolts.

 The help: if bolts for fastening of wheels cannot be screwed in a wheel nave the brake disk turned on a nave can be the reason. Turn it until apertures will coincide.





настоящая индивидуалка спб