Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
+ Injection system
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
- Kuzovnaja electrosystem
   Minus to "weight"
   Orientation in electrosystem
   Wires
   Plug connections
   The central switchboard
   The additional block of the relay
   The relay and management blocks
   The unloading relay of contact Х
   Safety locks
   The table of safety locks
   Electric schemes
   + The full electroscheme of car Audi 80: the 2-litre 4-cylinder engine (66 kw)
   + The 2-litre 4-cylinder engine (85 kw)
   + The 2,3-litre 5-cylinder engine (98 kw)
   + The 2,6-litre 6-cylinder engine (110кВт)
   + Additional equipment
   + The storage battery
   + The generator
   Condition check клинового or полилинового a belt
   Tension клинового a belt
   Tension клинового or поликлинового a belt
   Torn клиновой a belt
   Overheat of the engine because of damage клинового a belt
   The review wedge and полиwedge belts
   Replacement клинового a belt
   The list of malfunctions
   Starter
   The list of malfunctions
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications



Replacement клинового a belt

So поликлиновой the belt is put on a pulley at the models equipped with the conditioner.


In drawing passage поликлинового a belt at the model which have been not equipped with the conditioner is displayed.


 PERFORMANCE ORDER

  1. New клиновой the belt in no event cannot be "worn out" on pulleys by means of a screw-driver because arising cuts, so to say, predetermine the following breakage of a belt.
  2. To weaken an old belt for replacement.
  3. Now it is possible to remove easy it from pulleys, and the new belt can be put on them conveniently.
  4. Pay attention: if necessary it is necessary to remove and others клиновые belts, or you will need to disconnect a forward support of the engine.
  5. In summary to pull belts, to pass about hundred kilometres and then донатянуть.
  6. What клиновой where should be put a belt in Audi 80, you learn from the table above.

Replacement поликлинового a belt on models with the 6-cylinder engine

 PERFORMANCE ORDER

  1. To remove a casing поликлинового a belt.
  2. To establish накидной a key of 15 mm on шестигранник the tension device and to take away it to the right (bolts with зведчатой a head are sometimes established).
  3. To insert a pin (for example suitable bolt, etc.) in the aperture provided for this purpose and by that to fix the tension device.
  4. To note a direction of rotation of a belt a chalk or a felt-tip pen.
  5. To remove поликлиновой a belt.
  6. At installation to put поликлиновой a belt at first on приводной and directing rollers; in last turn on a tension roller.
  7. Again to raise the tension device a key and to remove a pin.
  8. To establish a casing.