Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
- Injection system
   + System of injection Mono-Motronic
   + System of injection Digifant
   - System of injection KE-III-Jetronic
      Basic elements
      Operating procedure
      Ljambda-regulation
      Malfunctions and independent diagnostics
      Independent repair
      Visual check
      Check of separate elements
      Search of malfunctions
      Removal of components
      Check of a mode of idling and the analysis of exhaust gases
      The list of malfunctions
   + Systems of injection MPI and MPFI
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications



Visual check

 PERFORMANCE ORDER

  1. To begin with check up air lines on tightness! It is necessary to check all hoses – from a thick sleeve of an air inlet to thin vacuum hoses.
  2. Whether as it should be sealing linings under the starting fuel valve and on впрыскных atomizers, and also фланцевые linings of inlet channels?
  3. Not tight places open access to not considered air, that is air which is not considered by air flowmeter and consequently essentially disturbs to mix preparation. The mix неконтролированно is impoverished. A consequence of it are malfunctions in work of the engine and rough idling.
  4. Whether it is possible to distinguish негерметичность топливопровода?
  5. Whether tips of wires have been repeatedly separated and again connected? Corrosion or inept actions can lead to insufficient contact.
  6. Attentively consider tips of separate components of system of injection. Uvulas of contacts do not bend, but only process a contact spray.