Audi 80/Avant (B4)

Since 1991-1995 of release

Repair and car operation



Audi 80/Avant
+ The description
+ Engines
+ System of release of the fulfilled gases
+ Cooling system
+ Fuel tank and the fuel pump
+ The air filter and воздухозаборные channels
- Injection system
   - System of injection Mono-Motronic
      Operating procedure
      Malfunctions and independent diagnostics
      Independent repair
      Visual check
      Check of separate elements
      Check of a mode of idling and the analysis of exhaust gases
      Check каталитического neutralizer and a ljambda-probe
      Trosovyj drive of "gas"
      The list of malfunctions
   + System of injection Digifant
   + System of injection KE-III-Jetronic
   + Systems of injection MPI and MPFI
+ Coupling
+ Transmission and transmission
+ Suspension bracket and steering
+ Brake system
+ Antiblocking system of brakes
+ Wheels and tyres
+ Kuzovnaja electrosystem
+ Ignition system
+ Illumination
+ Signalling devices
+ Devices and auxiliary devices
+ Heating and ventilation
+ Body elements
+ Search of malfunctions
+ Specifications



Visual check

Негерметичность in the field of admission system opens access to not considered air, that is air which is not considered at calculations of the block of management and consequently essentially disturbs to mix preparation. The mix неконтролированно is impoverished. Most clearly this malfunction is shown in unstable frequency of rotation in an idling mode. But the same malfunction can be shown in ringing noise of the engine working on full loading.

 PERFORMANCE ORDER

  1. To check up density прилегания vacuum hoses and presence of cracks. All hoses on the block of preparation of a gas mixture or an inlet collector (for example, the amplifier of brakes, preliminary heating of arriving air, system of evaporation of fuel) should be checked up.
  2. To warm up the engine and to leave it to work on single turns, to open a cowl.
  3. To sprinkle from a spray containing a fuel spray (for example «Startpilot») the block of preparation of a gas mixture about a flange to a final collector, consolidations of flanges of inlet channels and pipelines to the units operated depression (at the disconnected tip to a ljambda-probe).
  4. If frequency of rotation of the engine changes at spraying of a certain place, means, there негерметично.
  5. Whether it is possible to distinguish негерметичность топливопровода?
  6. Whether wire tips have been repeatedly separated and again connected? Corrosion or inept actions can lead to unreliable contact.
  7. Attentively consider tips of separate elements of system of injection. Contacts not to bend but only to process a spray.